So I thought this was the issue, and gave each and every element a unique name, as shown below: However, I noticed in the left sidebar that a lot of materials had the same name: I went back to Step 3 to check again for dupes, and there were none. However, I deleted all the duplicates I found (in Step 3 above)! Whats more - the SAME NUMBER of errors appeared when exporting (still ZModeler 1, to confirm), before AND after I deleted all the duplicate body parts I could find! Now, I assumed its the cause of the texture issue, and its happening because I imported two bus bodies into one model. "Material x already exists, and will not be saved again" x from ZModeler v1.07b, I got about 10 of these errors: HOWEVER there was a huge issue - the textures on the front and back of the bus (the only part involved in this entire post), were all using the completely wrong files. This worked well, as initially, without deleting anything, there was flickering ingame as two models were being displayed in the same place, but after deleting the duplicates and the unneeded stuff, flickering was gone completely. So, to solve this, I made a new ZModeler 2 project, imported BOTH the unused file with all of the body in one, and the file with only the front and back of the bus body, and deleted the left and right walls, and duplicate parts (one over the other), so that only the missing parts were added. It shows in OMSI, all textures work, but there are a few gaps because of small differences between the models as mentioned above (NOT because of any conversion errors). Now, this sounds complicated, but it works absolutely perfect.įirst time, it worked great. Select Left view > rotate -90 degrees (this doesn't work correctly when using dialog for some reason, but I do it by hand precisely and it seems to be fine)ħ.
obj to a new file in ZModeler 2 (I'm using 2.26 Build 981)Ħ. NOTE: The only process for all OMSI model editing is:ġ. Then replace this with the one used ingame. However, because the original file with only the left and right walls is the only file with the rear door gap correctly added in, I need to essentially recreate the file with only the front and back of the body, using the unused file with the whole body and the minor improvements, by deleting the left and right side walls.
There is also another unused file with both parts combined, but it has some slight improvements in the front and back details, which I want to use instead. Then both are loaded ingame, and they combine seamlessly. The bus body is split into two files - one file has the front and back, and another file has the left and right walls, etc. I'm using ZModeler v1.07b, and fixing a body of a bus for OMSI 2.
0 kommentar(er)
